Bones Motor Sports LLC
My Account:  Log In

0 item(s) in cart/ total: $0  view cart

m2c6575 TEKNO NT48 GAS TRUGGY CHASSIS

Part Number 169
review 0 Review(s)
0
m2c6575 TEKNO NT48 GAS TRUGGY CHASSIS
Email a friend Email a friend
Review this item Review this item
Price
Your Price:  
$159.98
Availability:
In Stock.
Quantity
Add to Gift Registry
Description

These chassis are made using 4 MM  thick 7075 aircraft grade materials and clear anodized.

use of the material greatly increases the overall life of the chassis.

we have tested and tweeked these chassis to provide the racers a top notch chassis that will perform very well on all surfaces.

This model is made for the tracks with a high wear charastic like the tracks we have out West,up north and in Canada

It is important to note that these skid plates fit flush to the bottom of the chassis and will not effect the droop settings and cause you to

scrub speed on the landings.

FEATURES:

We have made the diff cutout thru which will allow you to lower the cg of the center diff by 2 mm and added material back

to this area of the chassis to stiffen up this area. This should help decrease the possibility of broken spur gears due to chassis

flex.

We have also reworked the motor area to and deleted the stock motor mount and replaced it with a rock solid 3 pc quick change mount design that we have using on the mugen for years. we have also pocketed the motor mount area 1 mm deep.

this along with the mugen mount being 1/2 mm shorter than the stock mount lowers the CG of the motor by 1.5 mm.

An added benefit of the is that now you can now use about any starter box on the market desiged for 1/8 scale cars.

We have also included (2) 3mm counter sunk holes at the rear of chassiS just in front of the rear diff.

these are for our optional weight kit to increase rear end traction on looser tracks.

 

We have adopted this model so that if you wish you can cut off the front bumper to help the vehicle not to get upset on landings

and increse ground clearance. 

hardened front and rear replacable skid plate.

It is advised you replace the skid plate when the edge of the skid plate wears down to 1 mm.

This will make the chassis last much longer.

hardened droop  stops to prevent chassis wear and droop changes.

INCLUDED IN KIT:

skid plates:

m2c 6501 (front and rear skid plate)

m2c 6502 (front rear skid plate)

 motor mount: m2c 5230

OPTIONAL PARTS:

optional brass weights for rear of chassis m2c 5298

m2c 5231 top rails for quick change motor mount.